Servo Connector (trinket)
$12.00
64 in stock
Description
Sensor-Servo Connector is used to link the servo with the interface of extension module.
*Compatible with the DIY and mCookie series.
The servo can not link with the extension module (hub) directly, so a servo connector is needed. The servo connector have 3 above pins and 3 below pins, which can connect to two servos at the same time.

When connecting the servo and the sevo connector, please pay attention to the “positive and negative” , and make sure that the GND, VCC, and 1/2 three wires are connected rightly. The above pins is corresponding to the odd pins of Hub, and the below pins is corresponding to the event pins of Hub. For example, when connecting the servo to the 6/7 pin of Hub, if the servo is connected to the below pins, the control pin is 6; to the above pins is 7.
To learn more about Sensor-Servo Connector, visit our Sensor-Servo Connector Wiki page.
Additional information
Weight | 0.02 lbs |
---|
Questions & Answers
Questions and answers of the customers
There are no questions yet, be the first to ask something for this product.